Norstrec Designs

This is Part 3 of building a jet surfboard. Check out Part 1 here Check out Part 2 here

This is the second video where I build my own jet surfboard. Check out Part 1 here https://youtu.be/Xfa6EjZCL9E Check out the first test on the lake here

This video is the first in a series of building my jet surfboard. This part covers the construction of the battery pack.

This video was made as part of a class project for Embry-Riddle Aeronautical University.

This video was made as a class project for HU 323 at Embry Riddle Aeronautical University.

This video was created as part of a class project for AS495W at Embry Riddle Aeronautical University with Greg Reverdau of Pilot Institute.

This is the first test of the jet Surfboard. Everything appears to be working perfectly and fully waterproof. I hit the throttle too hard and bashed my knee though.

This is the first test of the jet Surfboard. Everything appears to be working perfectly and fully waterproof. I hit the throttle too hard and bashed my knee though.

Music by: Infraction This video was filmed using equipment supplied by Embry-Riddle Aeronautical University under the observation of Students and Faculty of Embry-Riddle. This Video was created as a class project for AS-325 taught by Gregory Reverdiau of Pilot Institute.

This is the first motor test using plastic gears for my jet surfboard. Motor: sss56123 ESC: Flier 320a boat Jet Thruster: 3D printed.

Music: Emotional Epic Cinematic Trailer by Alex CHE This video was filmed using the DJI Inspire 2 under the observation of Students and Faculty of Embry-Riddle Aeronautical University. This Video was created as a class project for AS-325 taught by Gregory Reverdiau of Pilot Institute.

This is a test to verify that all the balance leads are working for the battery

I have been planning out this table build for over a year and it has finally become a reality. Music: Barefoot McCoy - Ramble on October Paxton Pennington - Try Me On Check out my website: bit.ly/ncdesigns